Produksjonsstandarder for gravemaskiner

Gravemaskin bøtte is one of the key components of an excavator, og hvis det ikke er en bøtte, da vil selvfølgelig gravemaskinen ha liten effekt. Generelt sett, the bucket of an excavator is fixed and cannot be upgraded in the middle. In other words, if the excavator is used for cold water ditching, then even if you change the bucket to a standard bucket, it cannot be used in standard excavation projects.

Excavator bucket making process:
Cutting, low-temperature plasma cutting, steel plate casting, ear plate grouping, ear plate welding, boring machine processing, bucket grouping, bucket welding, bucket total welding, bucket shot blasting and rust removal, wiping putty, top coat spraying, paint spraying, all done after the bucket gets painted and sprayed.
The steel plate that will be pre-filled into the cutting machine will be cut with a CNC machine tool fire low temperature plasma cutting machine to cut out the ear plate, bucket plate, etc.
The whole process of casting is to carry out the actual operation of casting for the goods that have been cut long ago, and to suppress them into a certain look after convenient back welding.
Subsequently, the cut ear plate group cut good, this is to be in accordance with the provisions of the engineering drawings, the ear plate will be composed of a certain specification model, the data information on the engineering drawings is important, so be sure to pay attention to see, it is related to whether the key data information can be installed to the excavator.
After assembling, it is good to send to the welding area, which can improve the precision and reduce the deformation.
The boring machine processing is to carry out deep processing of the already assembled and welded trunnions, grinding and polishing.
Afterwards, the face-to-face bucket assembly is carried out. Here, too, the engineering drawings are used as the standard, and the dimensional data information must be accurate.
After welding, the bucket is shot blasted and descaled to remove the rust from the bucket and to facilitate the painting of the back side.
After the shot blasting and rust removal, the surface of the bucket can be painted when there is no rust.
After the top coat is applied, it is sent into the paint booth to carry out paint spraying. Som regel, the workers who wear thorough protective clothing do it in a professional room, and since the environment is very polluted, there is usually water coming from below to reduce the amount of flammable gas in the room.